1198 Titanium Axle Wheel Nuts ... Yes Or No

yes, blingggg

 

Titanium ones really tidy it up

 

Or 're zinc your old ones ??

 

Try podium racing in the states. When I changed mine (998 small axle) they were by far the cheapest. Less then one week delivery too.

 

my sixpenneth is watch the wheel side one if its that coned nut as you are directly turning the cone against the wheel when tightening rather than a separate nut and cone which if i was putting these on i would use two of the sprocket side nuts with the original cone and washer...

 

Have them on the 916 front & rear

 

Solution for undoing is an impact wrench. Subject discussed in several posts and there are several options. I use a DeWalt DCS889 18v cordless but you can get air and mains voltage wrenches depending on your budget, just so long as you get one delivering 350Nm. Andy

 

Yes, a tad on the small output I’m afraid. Andy

 

Clarke CEW1000. 450Nm torque. Does the job on my nuts.

 

Oooh-eerrr mrs. Andy

 

Yep this is the one I have. Your nuts would come of no matter how tight they are