Would anyone have one of these tools which bolt to the frame to set ride height. I would either like to borrow one or get some dimensions for a mate of mine who wants to get a couple made up. If any one has one for any of the other bikes in the Ducati range I could also ask to see if he would make them too. Mark.
I have one you can borrow but it's in Bexleyheath. Have you tried Alec at Pro Team? Ducati Pro Team Or Cranker put this up previously.
I took that dwg into the local laser cutting place in Bradford and they cut me a couple out of 4mm St/St. Only charged about £38 each so that wasn't bad. For fitting it to the frame I just used the MPL frame plugs and it worked a treat. Just as a note, if you have the two small holes where the frame plugs go reduced to 6mm, you can just use the frame plugs. Like I said, it worked fine but wouldn't line up on a 748 we tried it on. The spacing between the fixing points were 3 or 4 mm out. Ian
I have one but personally I would suggest you make sure your rear ride height adjuster will adjust and then work with that by increasing in small increments. I have my 748 turning beautifully now but still with plenty of stability.
