Did This Fall Off The Bike?

Discussion in 'Hypermotard' started by SiRich, Feb 6, 2017.

  1. Just cleaned the bike, after I'd finished rinsing it off I noticed this on the drive on the left hand side face down......has it just fallen off my bike I can't see anywhere obvious? It's made out of rubber and about 2 inch by an inch :Depressed: IMG_2334.JPG
     
  2. what bike? Looks like a bung out of a swing arm on a 748 916 ect. Don't remember em saying up on em though. Or heard of one falling out
     
    • Thanks Thanks x 1
    • Nuke Post Nuke Post x 1
  3. sorry just noticed its in the hyper section.. Don't know if they have the bungs or not
     
    • Nuke Post Nuke Post x 1
  4. You are about as much use as men's tits :rolleyes:
     
    • Face Palm Face Palm x 1
    • Funny Funny x 1
    • Nuke Post Nuke Post x 1
  5. Chizel is right ya know!!! just stuck my hand behind the front of the swing arm where it meets the frame n there is an oval gap there.

    Only used a hose pipe to wash it, bit rubbish that it dropped out.
     
    • Like Like x 1
    • Thanks Thanks x 1
  6. It was a lucky guess :)
     
    • Funny Funny x 2
  7. I was going to guess that too :Angelic:
     
    • Nuke Post Nuke Post x 1
  8. You'd have been lucky too :)
     
    • Funny Funny x 1
  9. Think an apology might be needed there ET :D
     
    • Agree Agree x 1
    • Love You Love You x 1
  10. The lady's not for turning (ET) :tearsofjoy:
     
  11. obtaining one has same odds as Donald Trump marrying a Muslim.
     
    • Agree Agree x 3
    • Funny Funny x 1
  12. ner ner na ner ner :Cigar::Finger:
     
    • Like Like x 3
    • Nuke Post Nuke Post x 1
  13. Well done chiz ET will be along shortly with an apology ;)
     
  14. Takes a man to say sorry
    I'm waiting....... :Writing::Bookworm:
     
  15. That's the problem with that failed Ducati experiment, the single-sided swing arm ... you just cannot get Hell Tee to apologise for them.
     
    • Agree Agree x 3
  16. It's defo out of the swingarm, but.... if it's fell out, chances are the arm has water inside it. Put it on a stand and loosen the hub pinch bolts. Most the water will drain. Once it's done dripping, don't forget to tighten it back up.
     
    • Like Like x 1
    • Useful Useful x 1
Do Not Sell My Personal Information