959 Evotech Tail Tidy And Dp Led Rear Blinker Advice

Discussion in 'Panigale' started by Den, Jan 8, 2018.

  1. Typical newb question probably. I’m just pulling the trigger on an evotech tailtidy and some dp rear indicators. Will they fit together. I saw on evotechs site they sell small rubber rings for ‘aftermarket indicators’ but cant find an answer on the web if I need these or not for the do version. Any advice appreciated...
     
    #1 Den, Jan 8, 2018
  2. You could take the rubber bits from your stock indicators.
     
    #2 Gweev, Jan 8, 2018
  3. Do those work with the DP indicators? I assume they would mount on the existing rubbers, but I used standard (well, 1199) indicators on mine, so don’t know.
     
    #3 Jolley, Jan 8, 2018
  4. Ah. Yes I did the same come to think of it. Sorry.
     
    #4 Gweev, Jan 8, 2018
  5. Got them on ours, no fitting issues, looks the bollax
     
    #5 Brom66, Jan 8, 2018
  6. Cheers for the thoughts guys, I knew I was over complicating things. Anyways all ordered and on there way. Looking forward to tidying that back end up. Ta
     
    #6 Den, Jan 8, 2018
  7. If it does use the OE rubbers, good luck getting them into the Evotech holes! I made sure my were nice and warm, start with the slightly pointed bit first, then twist and push... the first one took me about an hour to figure out! Tried washing up liquid and all sorts!
     
    #7 Jolley, Jan 9, 2018
    • Like Like x 2
  8. Cheers for the tips..weekend of scraped knuckles and scratching head await.
     
    #8 Den, Jan 10, 2018
  9. I soaked mine in boiling water to soften them a bit first ( the rubbers not my knuckles!).
     
    #9 Gweev, Jan 10, 2018
    • Like Like x 1
(You must log in or sign up to post here.)
Do Not Sell My Personal Information