Hey.. I just finishing installing a QS sensor on my 1098... connected to PCV I tried to make a test like Dynojet describe..where I put rpm down to 1000..at kill time to 250ms.. then start the engine... in idle... and put it in 2 gear.. with pulled clutch..then the engine should die... but it dont... so i beleive its not working I tested the switch with an multimeter..and it working..shifter setting in PCV ..i put always open Du I have to install some QS software?? to the PCV.... or is it enough.. just to put.. the QS settings to on...in the PCV??? and connect the 2 wires to the 3 and 4 hole in PCV??
