Separate names with a comma.
Hello, has anyone had any success in improving these forks? I was thinking of getting mine upgraded with the Maxton GP20 inserts, but it is very...
http://m.ebay.co.uk/itm/263002020720 Monster 600 with a 750. It's a category C and not registered as a 750. Also has more dents in the tank than...
I don't know if this is old news or not. Copied from their Facebook. Hi from California Cycleworks! Just a note to thank you all for your...
For £600 new, are they worth getting to go with some unbranded absorption type cans on my 1995 900SS? They say you get an 8hp increase in the...
I'm needing a Supersport tank that isn't rusty inside or out, or at least isn't leaking. Started welding up mine and it looks like the whole back...
Afternoon. Does anyone know if the 600SS airbox will fit a 900SS? Got an FCR kit and don't want to cut up my unmodded 900 airbox. Thanks.
I don't do much town riding and I like tall relaxed gearing, although I might find I'm using 5th gear a lot. Do alloy sprockets wear more than...
I'm looking for some good carby 900SS forks or some good fork uppers....or some non adjustable Showa forks with the same fork uppers. Also seeking...
Hello. I was wondering what I could to with my 900SS (1995) Showa forks, the outside, up near the yokes, has corroded and some of the metal is...
If anyone has a pair of these collecting dust? Preferably from a 900SS so there is the tacho cable drive. Thanks.
Hello, I've been trying to clear the rain water drain in the lock recess on my tank filler, but it's not clearing. I've tried compressed air at...
Got a W2 headed engine in my old 96 900SS (from a monster, didn't know when I bought it) and wondering if a 2002 injected motor would fit in?...
[IMG] I'm enjoying my new Multistrada, I was expecting the Ohlins forks to be something special, but they suffer from stiction, (I'm 13 1/2 stone...
No prefix for the 1100s! I've just put a deposit down on a 1100s MS, going to need one or two front discs, bit of warping I think. I have a carbed...
The throttle slider on my 1996 900ss measures 26.5mm, across the diameter, not just raised ribs or deformed but everywhere I measured and the...
I found it behind my workbench today. 1979 original, printed in Italy. Pages all intact and in good condition. There are 2 pages with some...
I've just done from Laurencekirk Aberdeenshire over to Lochgilphead argyll via crainlarich, then up to fort William then spean bridge then past...
I can't read the wheel bearing code/numbers to replace my rear wheel bearings and sprocket carrier bearings, wondering if anyone knows what the...
Can anybody tell me if a 1998 750 SS steel swinging arm will be a direct swap onto my 1995 900 SS? My aluminium swinging arm has an M10 bolt in...
