Separate names with a comma.
Duc996bp.. going with copper grease.. need to ride this bike. when this snow gos away. :/
Thanks Denzil.. Noted.
You reckon copper grease is the one to used, so it doesn't cease when tighten after at 6 nm?
Guys, got my replacement pinch bolts now (for my Marzoochi forks to tight front wheel axle), torque settings spec sheet says to dab some "Shell...
Nice bike:wink:Have you been on the track on the r6 yet royalwithcream? If you have, how does it compare to your Panigale?
These bolts are the 6mm M6 which is 6Nm on the manual which I torque to 19nm by mistake. Pfff [ATTACH]
I had a look at the list of torque settings again.. I think the settings are wrong cause there 2 type of forks on the S Version.
Centre punch the top of the strip head to release tension, after spinning the bolt from the gap on the side of the fork with a slim flat head...
19nm, I set the torque values as these settings are for "Ohlins fork feet clamps to clevis pin fastener only S version" Which I think it's wrong,...
Almost Quantuman…. Took the fork leg out of the bike, put it on a vice, centre punch the top of the strip bolt then with a thin flat head...
Guys thanks for the advice once again.. been reading all your interesting techniques and replies.. I'll take note of all the advice you given to...
Thanks guys... for your advice and help once again.. and of course your time. i let you know the outcome. :wink:
like doing the impossible chizel? give me a medal if i get this.. :/
Tobytyke or anybody can answer this and might look like a utter twat, there two type of forks on the 1199 S 2012?
im thinking to myself, using a snap on torque wrench- are they suppose to snap bolts yeah snap off clean.. use snap on. pfff
just had it repaired then this happens.. its that hole is tiny and tight.
blanked off
Bummer, phone decide not to take pictures.. pfff You can still see the thread from the side as there is a cut from where the bolt gos through its...
[ATTACH]
