Separate names with a comma.
Good news on the map sensor :upyeah: I’m not sure liquid gasket will survive the temperature of the exhaust manifold, best just to get a new...
I think you’d be very hard pushed to find a 998S these days let alone find one under £10k, no?
Interesting take on the situation here, smacks a bit of the Norton debacle....
It does depend what the parts are and whether they’re on back order at the factory or not. You could always try someone like StarTwin in NL,...
Yes, just the single MAP sensor as there’s only a single manifold from the air box to the cylinders. It’s a £40 part, may as well order it from...
Well, it seems from Nelly’s response in the other thread 140Hz is what’s in the workshop manual. I’ll admit I’ve only ever used the ‘Allen key’...
Fuel level sensor issues won’t affect the running of the engine, they’ll only affect the display on the dash of how much fuel is left and the...
Presumably you plugged the bike into a diagnostic computer of some sort in order to see the errors. When it reported fuel sensor error what code...
I couldn’t find the posts on here but found some photos from the time [ATTACH] [ATTACH] [ATTACH] In the last photo the top cap is the one with...
I had a Monster 1100S a few years ago, from the day I got it there was always a clacking sound from the front under sharp braking. I lived with...
I think you’ll have to disassemble the fork cap/preload adjuster/stepper motor and work out what’s going on within. I would have thought it...
I use the Gates Carbon Drive app which works consistently. Just need to make sure there’s minimal/no background noise and hold the phone’s...
Useful, thank you. It’s strange how the parts fiche doesn’t show any 1262 models until 2018 though :thinkingface:
No. I don’t think I’ve ever seen that.
An acquaintance has a 2016 registered XDiavel, the 10th letter of the VIN is a G which denotes the bike was built in 2016. However it has a 1262cc...
This is the stuff I use on the pistons and the seals when rebuilding and when cleaning a caliper. it’s from a company called ATE. [ATTACH]
When you disassembled the forks to change the seals did you back off all the preload before removing the cap?
Preload is set on each fork leg by adjusting the big blue nuts, clockwise screws it in and increases preload, CCW decreases preload. It’s not...
NOK are good seals, I’m fairly sure they make the seals for Ohlins. I’ve forgotten which bike it is and what the forks are, are they Ohlins?
That spacer is there so you can drive the bush in without damaging it. The seal rests against it, but it won’t affect the integrity of the seal...
