Separate names with a comma.
Ok got some new bearings. Putting the crank cases back together and shimming. I had a gasket I ordered a while ago as a spare. I have come to put...
Is there something about the small wire/connection to the relay coming off / loose, did you check that? [ATTACH] Cheers Gaz
Thanks Paul, Desmo & Mnine. Got some plastigauge on order. Conrods are B with yellow paint, crank has -2B written on it and a 2 stamped in it....
Any recommendations for recovery and insurance (in addition to bike insurance) and any other finer details. Cheers Gaz
Brill, Wanting to do something next year (if the bike is back together) have great trip, well envious. Cheers Gaz
Here are a few pic of my bearings and crank shaft journal. Again thoughts please, presume wear is excessive. I measured journal at 42.00 41.99...
So I decided to drop the engine, don't ask why, I don't really have a proper answer just a few niggling feelings. I've slowly been adjusting the...
I believe there is a little bit of adjustment in the bracket holes, this may help to reposition. From memory I think I pressed down a little bit...
Little job today. Put bearings in a bit ago. Seals and retaining clip today. Bit of a fiddly job but got there in the end. [ATTACH] [ATTACH]...
Tbay, Intresting, good report. Have you got the part number or info on where to buy. Cheers Gaz
I tried that and it was a bit easier. I "thought" I felt it slip a bit - could have been wrong, but it got in my head and I put the springs back....
I did start changing up without clutch but not down. I did see another one on ebay by "duc or die", and others. I did find something regarding the...
Yes, simple stuff first. Are leads plugged into the correct ignitors? (Can't quite see your colours in the photo, I got it wrong). Mixture screw...
Sam, First great write up of you tour, hope you enjoyed it. Second did you ever use the pump i.e. did you try it out on the flat Motorbike tyre....
Sorry to hear this, RIP.
Yes, I did notice that thanks. [ATTACH] Cheers Gaz
So I think as Guillaume said be mind full the collets may not be seated correctly, I am sure this was the case at some point during the...
Hi Guillaume, thanks for responce. I going to shown my ignorance and ask what does D2, D3 & D4 refer to, I presume it's 2, 3 & 4 Valve but have...
Yes knew there was 2 different tools, I just thought my micrometer who's diameter I mentioned earlier, and is bigger than the hole might be the...
Cheers, so am I but don't hold your breath.