Separate names with a comma.
Okay, so I read the idle jets are 40 as standard, so I ordered 37.5's and 35's. Pulled them today and they had 42.5's in them. Put the 37.5's in...
I don't know, I was told belts were done but was given no receipts, so not holding my breath. How often does that need to be done? The bike has 7k...
Hi All. I've chased down a poor running condition on my bike and mostly resolved it but along the way I found one potential issue. I wasn't able...
Cool, thanks. I've already dropped the main needle a notch. I'll keep dialling down the idle mixture until it runs noticeably worse and see if...
Cool, thanks. I've been adjusting that but it doesn't seem to change much with this problem. I thought there were three jets, idle, pilot and...
Oh, are the pilot jets adjustable or do you mean the idle jets?
Okay, new floats in and no overflow. It still starts to miss in the midrange at extremely small throttle openings. I've been pulling idle jet from...
*phew* glad you sorted it. Just for general knowledge, I've never had success with screw extractors and when they snap, you are totally screwed....
@Shazaam! Just one thing to add, there is also ceramic based anti-seize. (according to the marketing) it pretty much stops galvanic corrosion as...
I'd suggest using sandpaper on the pads and discs rather than concrete, then bed them in again. Also make sure there's no grease or oil...
The float level is super easy to check. Get a bit of clear silicone tube that you can fit to the drain. Point it down into a container. Open the...
Been working on a few other things but figured I would have a crack at finishing this. Pulled another half turn from the idle jets and it was...
Dropped the needle and it's a little better. I've got one more slot that I can go to. Are the needles the same between all the jets or does each...
Okay, FINALLY got the new jets. Running better but not cured. Bikes wants to pick the front wheel up in first and second now but still not happy...
I haven't forgotten about this but my jets still haven't arrived and I'm away for 3 weeks now. Hopefully they will be there when I get back
132.5 and 140 jets ordered with new o-rings. They also have clear float bowls available, though checking it isn't hard on the bike.
Ha ha, put it down to new rider enthusiasm. It's been either fix this or don't ride. Though I have a second bike now but I feel I'm close to...
Thanks. I've been on my back at the side of the road many a time adjusting the idle mixture. Had it as low as about 1 turn on the idle screws all...
Okay thanks, does it somehow shut off at higher load or is it just insignificant in the scheme of total flow at that point?
Thanks Derek I think what I'll do is go back to stock jets and keep in mind a full rebuild with new slides if it still doesn't run correctly....
