Bought this from a forum member a while back and paint was rough. It's sat in the garage for ages and I recently found a panigale front which I'm now using (forged) Just been powder coated but is a little orange peely However it still looks lovely and I have a couple of marchesini rim decals and a red stripe I can supply with the wheel if needed I have the center spacer, old bearing and seals supplied also Looking for £220 posted Runs straight and true
There's a lot to be said for increasing the number of apprentices in various industries but then again letting them play around with customers possession's should be prevented until they at least learn to open their eyes when applying the powder.
It looks worse in the flash but it's there none the less Always get a little with powder but it's worse than normal! Lol It's a good even coat though and new with no chips etc. the spokes aren't bad but the rim flats are like it all round. Still look pretty and shiny on ya bike guy said he used the same grade shot as on my Magtek but it marked easily The Magtek was fine though
It came from a 1098.... It's the same fitment as a panigale lol also a multi strada pikes peak Thought they were all the same I'll measure across the disc surfaces in the morning...its a 17/3.5 rim the same
1*98 848 fronts ARE different to 1199/899 wheels. They need a disc and bearing spacer kit to fit the Pani series. 1*98 rear wheels fit tho
My wheel slotted straight in as per my pic unless it's not a panigale wheel Makes no odds to me what it came from as it fits fine It's a three spoke that splits into three more on each spoke I bought it cause it's forged and lighter. As you can see I have PFM discs , 1098 forks and yokes and Brembo mono calipers... Both wheels fit straight in with the same discs However back on track.... It's a 1098 wheel so I know it fits a 1098 and I'll measure it's width across disc mounts am
