Theside fairings appearto have two plastic bolts with pins in the middle which attach the inner splashguards at the front Not sure what is tyecorrect way to remove and install these plastic bolts? What do yu do with the pin and the collar on the outside? Thanks
Just use a small trim tool or small screw driver just lever under the top part gently and the centre will come out if you use a tx 30 it normally spins the whole lot and to refit them you just locate them in the fairing and push the centres back in with your finger
The correct way to remove them is to depress the middle pin then lift the whole thing out of the hole/fairing. To put them back in then pull the centre pin out so it sticks out then put the whole thing in the whole then depress the centre pin so its flush.
