Rear light and number plate holder

Discussion in 'Multistrada' started by Tripletrouble, Apr 13, 2012.

  1. On my bike it wobbles around like there's no tomorrow.
    I tested the fastners, all tight so it looks like it's designed to do this, is this right?
     
    #1 Tripletrouble, Apr 13, 2012
  2. #2 Anthil, Apr 13, 2012
  3. Be carefull , I tightened mine up with washers and the light fitting broke away from its base (I only realised when i got a brakelight fault so had to check the wiring) I superglued the bastard back and shoved it back in and its workin so far.
     
    #3 pumpman, Apr 13, 2012
  4. The same thing happened to mine and was replaced under warranty

     
    #4 Nigel Strada, Apr 13, 2012
  5. Great stuff, thanks all.
     
    #5 Tripletrouble, Apr 13, 2012
  6. Fixed. 4 M10 washers and all is good.
     
    #6 Tripletrouble, Apr 14, 2012
  7. I inserted the spacers to successfully reduce the movement in the tail light and number plate holder but found over time the tail light itself became very loose. Fixed by pulling the holder apart to reveal and tighten the two screws that hold the tail light onto the holder.
     
    #7 RBlacky, Apr 17, 2012
(You must log in or sign up to post here.)
Do Not Sell My Personal Information