I'd be tempted, but I wouldn't want to cut into any Ducati wires. Does this work with CAN BUS? What bike did you have it on? I can't seem to find a technical manual as to what sources it picks up on.
My missus complained that the pegs are too low, i actually thought that would be a better riding position, but no, we have had dozens of bikes, she says when the pegs are higher your knees are closed up, and they take act as a spring, taking the impact off your back, so that's another job to sort, are there after market higher pegs or an adapter kit available to raise the passenger pegs?
I have a full technical manual for it as a pdf and can email it to you if you want to have a look. I had it installed on my Multi GT 13 This is the basics of the connections to the bike from the main unit. I'm pretty sure that I managed the installation without cutting into any wires or even using 'Scottish-lock' connectors - I just 'piggybacked' into connectors. 1. Black - Earth - Typically wire to a known earth wire, Frame mounting or Battery negative 2. Red - PowerNote the 1 Amp in-line slow blow fuse that MUST be used. Connect to a 'switched' live off the ignition switch. Alternatively connect to the rear light positive wire. IMPORTANT: - bike HUD draws around 1.4mA. If you connect to an existing circuit such as rear light check with your Dealer that this does NOT cause issues with the CanBus sensing Bike HUD as an over- load on the circuit and triggering a fault. 3. Grey - Side stand 4. Green - Right Indicator 5. Yellow - Left Indicator 6. Orange - Neutral Light 7. Brown- Main Beam 8. Blue - Engine Sensor - Depending on the ignition type there are two ways of fastening the sensor.1.) Traditional HT lead and separate coil - identified by a thick wire ending in a small cap that is a press- fit onto thespark plug. Cable-tie the sensor around 100mm length along the lead starting at the edge of the spark plug cap. 2.) Coil on Plug identified by two thin wires connected to a larger plug -cap that is usually fastened to the top of the engine. Wrap the sensor wire 4 times around the base of the spark plug cap
Top Box for 2010-2014 red complete with fitting kit and all attachments, all you have to do is add your barrel. There are a couple of minor scuffs on the paintwork very hard to see in the photos. The support legs had some light corrosion which I removed and gave a fresh spray of paint. £250 delivered, collection or delivery on Tyneside preferred.
I have a brand new Head Light Fairing / Cowl for a 2012 in red. suspected it will fit all pre DVT bikes but please check before buying (part number in image below). Part ex'd bike so decided not to bother fitting. Cost me £354 incl postage. Will let it go for £280 if collected (no offers please). Or buyer pays postage. In original shipping box
GIVI Easy Lock Tankring Tank adapter BF11 £8 including UK delivery Red touch up paint + frame touch up paint (two small pots with brushes) £12 incl UK delivery. Both been used once so virtually new.
Evotech Performance Radiator and Oil Cooler Guard Fitted these in Feb this year however, they are no longer required. In (almost) as new condition bar the little mark in the radiator guard (see picture). £75 posted.
