Separate names with a comma.
I have a set in my DP slipper clutch, the set i use are not the sintered but as the DP catalogue says,964060AAA carbon plates. The sintered plates...
The push rod has 2 x 0-rings they have to pass through the small oil seal at the end of the shaft, put some grease or oil on the push rod and work...
Sounds like the sprag clutch for the starter gear has given up. brian.
The T.P.S would be my first piont of call. brian.
Have a look here,Nichols Sport Bikes | Products | 748 - 998 Superbike or you could look for braketech they did do a nice floating bolt on rear...
Is the wheel spindle located correctly in the lower fork clamps. brian.
Matris do a aluminium joint that fits . brian.
38:mm. brian.
just for you Chris. :-) brian. [ATTACH]
Click into gear 0.38 ish sidestand still down oh dear. brian.
Bulkhead fittings sound like the part you are after. or electric cable gland fittings or conduit fittings but depends on what the part has to do....
Clean the pick up tags inside the dis/cap as they can fur up stopping the spark to the plugs. brian.
The new Haribo starmix advert is just so funny.
The brass drift needs to be square, i agree with Bront it looks like its tapered ? so you get a good solid face on the thin spindle surface. some...
As its in bits take a GOOD look at the starter sprag and inner and outer surface that the sprag grips on in the two gears. brian.
