Separate names with a comma.
Took mine to France, Italy many times always camping wonderful times [ATTACH]
Mine failed but on the middle exhaust supporting part, the thin metal plate that the exhaust bolts too, was told by welder it just was a bad weld...
I crashed at 50mph approx hit diesel spill on a bend spyke leather jacket and Red Route armoured jeans jeans did the job,denim wore threw on knee...
I have the same setup to stop this and pull the tail section down a little lower I put a cable tie around the pin with second cable tie held by...
Did you remember to put the little top hat shaped sleeve back on the pushrod or could it be stuck in the end of the old bearing this would cause...
It was me :smiley: do it every year run on a timer along with optimiser comes on at 6 am off at 12 noon every day never any condensation pence to run
No take all the coils stick out dry that in the resess the spark plug sits down in I used a hair dryer. When you put back put some high temp...
The moisture will not evaporate as it sealed in as such,it be ok to ride home steady then sort it when it starts running in just one cylinder you...
You could have got a slight bit water ingress in your top coil . If a small amount water was pooled around it the vibration on starting could have...
A question re the clutch friction material if measured does anybody know the approx thickness when new or when to consider replacing. I going to...
Do the rider bootlegs come with gear shifter Cheers
Just need the alarm to go booooo when you open the door instead of beep
I get condensation in my garage and just use a cotton sheet and run a 40 watt light bulb in a clip on light bulb holder clamped onto the trellis...
Then if the exchange rate swings the other way for a long period they never swing back down !
No no was just reading the thread on my phone didn't even know my finger had pressed a emoji
