Separate names with a comma.
Yes from about 1995 iirc
It's a very simple circuit, so a new switch certainly seems like the solution. As regards the rear, I'm not familiar with your particular multi...
Paul, the JE compression was up about 13 to 1 not lower, but it had some go! PM sent
JE are good, but their quoted compression was a fair bit lower than what I ended up with. When I went from 92mm to 94mm pistons, I got the Pistal...
You're right, if the plates start to mushroom, then the clutch just gets louder and louder. Folk sometimes think that the plates need replacing...
A satisfying mod to do, glad it worked out. I did it to mine, and it made little difference, as the basket and plates are steel and it has an open...
Let us know how you get on, sometimes it just takes ages to bleed, but a new kit will no doubt solve your problem
If the master is full of fluid, it should produce bubbles from one of the holes when it is pumped, as the air in the line is replaced by fluid. I...
Issue 1. From your description, sounds perfectly normal 2 of the bolts are long and for holding the clutch case on, they pass through the cover....
And double check the polarity, if the contacts have been swapped during work.
My mate has one. I'll message him Stein Dinse had this....[ATTACH]
I've not come across this before, if its a carb model I would've thought it would have 2 pickups. However my 2002 900ie SS was a crank sensor due...
Currently building a 1987 Elefant 650, Cagiva/Ducati hybrid
Do you not have 2 pickups? You should have, all the Ducati twins I've worked on have. Anyway, I appreciate what you're saying. There's a lot of...
A very wise idea, it's worth doing the pickups and all wiring too. They have a new version of the Ignitech, you're looking at the SPARKER...
