Separate names with a comma.
It is only the 899 & 1199 that uses the outer cover to hold the idle gear in place, the 959, 1299 & V2 uses a screw and does not locate into the...
It's a straight forward like for like swap, just be prepared for the extra mechanical noise of the steel gears. [ATTACH] [ATTACH] [ATTACH]
Who knew it could be so complicated ?:confused:
You can run an external earth wire from the bikes diag connector to the earth terminal on the battery, this will give you the same earth...
Not everyone does :) [ATTACH]
Yes, all four bulbs are H11.
I have this one for sale: https://www.ebay.co.uk/itm/267074455694 [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
Is it just the rear set hangers and pegs that you need, or complete with gear and brake levers ?
Is the problem that the push rod is spinning and destroying the seals ? If so check that the thrust bearing in the pressure plate is free and in...
All single sided wheels are the same, it's the well that is offset, nothing to do with strength.
https://www.ebay.co.uk/itm/266721337181
Hi, Sorry I sold them about 7 and half years ago. Kev.
It's worth it for the sake of two screws. [ATTACH]
I have this low mileage one for sale, but it's a bit more than £4k. [ATTACH]
I'm going for most of the races. [ATTACH]
