nelly's Recent Activity
-
nelly liked Topolino's post in the thread Grab Yourself Some Popcorn. This Might Take A While..
With that job done I had to fit the rear carbon shark fin chain guard. This is held in place by the hydraulic line p-clip on the swing...
Nov 17, 2024 at 10:40 PM
-
nelly liked Topolino's post in the thread Grab Yourself Some Popcorn. This Might Take A While..
With the plate fitted I could turn my attention to the LHS lower wiring loom, which includes the sidestand switch, gear position sensor,...
Nov 17, 2024 at 10:37 PM
-
nelly liked Topolino's post in the thread Grab Yourself Some Popcorn. This Might Take A While..
Crisis averted! Switched the link bolt around and now there is plenty of clearance. A noteworthy point, if anyone else intends on...
Nov 17, 2024 at 10:32 PM
-
nelly replied to the thread Valver Clearence Help.
You’re in spec on all gaps for checking. The measurements you list as “operation” are the assembly figures. The 2 closers you have at...
Nov 17, 2024 at 8:35 PM -
nelly rated Steve Robins's post
Useful in the thread Crankcase To Cylinder Clearance 916/955?.
When I built my 955 851 I turned down the outside of the 916SP barrels to 101mm and then machined the c/cases to a sliding fit. This...
Nov 17, 2024 at 3:38 PM