Separate names with a comma.
Thanks, did realise this. I’ve put the heat retardent tubing on so it may help it last but will look to change it annually. Just wanted to give it...
Yes and so the current 40 million cars in the country don’t all need scrapping.
I’ve just completed a few jobs over the winter months. Heat retardent tubing over the rear brake hose. Motul 660 brake fluid flushed into the...
Solid state batteries will address a huge amount of the issues current batteries have however I think it will eventually settle out into some form...
It was easy. I was just being thick with the spring plate. The clips on the back just needed bending back so it fitted over the caliper. Once I...
How the heck do you get to the servo plug? Been having a look round after taking the seat off. It’s tight down where it is. I’ve got the Healtech...
It’s quite a weighty bit of kit isn’t it? Would like to take it out. Got the healtech I need to plug in.
I didn’t strip it but I cleaned the caliper. The pistons were shiny mint and I çan slide them back in easily without too much pressure so though...
Could be that one of the pistons is sticking. One coming out before the other. Could be not going back in. Binding since I’ve put in the 660 fluid.
Thanks so much West Cork Paul. Much appreciated. I’ll check your brake thread.
Does the retaining spring plate sit in the middle? Can’t seem to get it to lock in place. It just moves and falls about.
I’m worried I’ve slightly bent the brake attachment plate when I was prising it off. Hope not. Other than that the only possible other thing is...
I used this...
https://imgur.com/a/r4KFVcn looks close on the left side but decent gap on the right. Is this normal or should it be bang in the middle?
