Separate names with a comma.
Yes it is... Take a look here: https://www.ducati.ms/threads/gas-cap-lock-cylinder-removal.135664/ Best Andreas
Up.
As above in mint condition, open for offers. Front: 3.5 Rear: 5.5 as OEM Andreas
Hi Bill, there is a small (ca. 1mm) drilling in the inner flywheel that has to be aligned with the corresponding drilling on the crankshaft for...
Hi, I bought this Titanium motor bolts for my 999: Titanium M12 x 1.25 Taper Head Bolts Cone 1.25mm Fine Pitch Length: 250mm...
How much for the engine? Is it the late R with 150PS?
See TPS Sensor: https://www.ducatiforum.co.uk/threads/749-999-money-saving-tip-for-broken-tps.14226/ and How to replace...
Hi, if the value coming from the TPS in JPdiag is jumping as described than most likely your TPS sensor is faulty, you have to change the sensor...
Hi Adam, the voltage while running should show 13.9 - 14V. Hook up the Laptop and look at data from the TPS sensor while pulling slowly the...
I would just sent Dragos a short message via Facebook and just ask him about the correct length of the brake hose. He is a very nice guy and very...
Hi I bought the same kit for my Ducati 999. I compared the needed bolts up front and only a few where needed to be bought extra. Good value for...
Hi, yes you have to remove the black plastic part. carefully use a flat screwdriver to remove the clips ... take your time, you want to reuse...
With this kit you just have to exchange the part. The ressin epoxy is only needed when you decide to repair the part on your own. Having done both...
You can order it here: https://www.stein-dinse.biz/product_info.php?language=en&products_id=452298 So did I....
