Separate names with a comma.
Yes, not a straight swap - hence the 'engineering' reference. It wasn't too difficult though, and gave me a set of better looking wheels ( to my...
If you're up for some simple engineering, Fireblade wheels will fit. Did this on my SL, saving nearly 3.5kg. There's a thread on the Supersport...
Stupid me - should have read Desmo's post first.
Rub the alloy with ordinary bathroom soap. Heat up and when the soap turns black, you're at annealing temperature.
Could always leave cable ties off altogether. For me they spoil the look, so with a couple of cable tie 'blocks' attached to the sides of the air...
Before adding bits to the stand, check for wear in the pivot bush - they're not brilliant and a small amount of wear in the bush is obviously...
When I did mine, Ducati John in Leeds was good enough to loan me the factory puller overnight. Might be worth a call?
Yes you can, although you'll need to take a bit of care supporting the case/crank when dealing with the plug. Irrespective of whether you can get...
At the least, I'd go with (and have), upgraded starter cables (why piggybacked?) and Mosfet R/R - these are the bits that seen to give most...
Maxton did mine - they did gas and oil but IIRC they said replacement seals weren't available.
1996 large breather - "Made in Italy" only.
Yep, done that. Dead straightforward - only issue ( minor at that) was adjusting the shimming (crank and gearbox) to allow for no centre gasket -...
Leads reversed?
Aren't the 3 ohm ones supposed to run hotter? - need to be out in the airstream.
Yes - thats what I use
If you can/want to dismantle the switches to separate the red items, Rit Dye is supposed to work quite well on plastics.
You probably need to use a puller to get the cover off - simple piece of bar with three holes will do - outer two @ 6mm to thread bolts into the...
For the pair. I sort of expected more, but the bars are solid for nearly half their length. Still, they were cheap!
FWIW, I'm using (alloy) GSXR clipons, mainly cos they're neater - 250gm lighter than the stock clipons.
I'm not about to argue - I'm just stating good engineering practice. I have a T-shirt as well.
