Separate names with a comma.
Considering he worked this engine stand mount out from what I sent him above he did an incredible job. The stand was made in 2009 so it clearly...
I managed to find a few more bits of information which allowed me to have the engine stand built. I should add that apart from the stand I also...
Here are some photos of my engine stand made by a member on here who is no longer active I think. [ATTACH] [ATTACH]
I probably didn't portray what I meant which was removing the wheel from the bike for work on the front end, not just getting the stand from under...
The only drawback I can see is that the front wheel only sits on the stand so you can't actually take the wheel out without a proper front paddock...
I came across this today, a couple of totally maneuverable bike stands that would be ideal for my cramped workshop, maybe even for trackdays etc....
I only had the pads on my 998 when it was new but having purchased several 748 panels over the years none of them ever came with the...
Clearly, I misunderstood your post. I'd agree, replace the bleed nipple and give the seat a good cleaning out. Unless there is damage or dirt in...
Are you using the correct copper washers around the sides of the clutch fluid line? I assume the 1199 uses them as standard. If you do have them...
I use them on all my bikes and they make quite a bit if difference, worth the change.
Same here increase by £100. Looked at going third-party fire and theft and there was virtually just a few pounds drop.
The originals are quite long and on one conversion I did I had to cut one in half to make it the correct length. As above this is for the...
Had this on a track day, I got flagged down by a marshal and my caliper was on fire! Luckily rear disc was Ok but the rest was finished. Best to...
I remember seeing him for the first time in the Barry McKenzie film when he played just Aunty Edna as a one-off. Always loved him as Sir Les...
Yes, as I understand it, brake caliper bolts, studs and nuts for the exhaust ports and anywhere else where a bolt is subject to a shearing force...
You could try having it ultrasonically cleaned and if nothing else the pump baseplate might come up a lot cleaner. Do you know if the fuel level...
I had the same problem but used brake cleaner and squirted it in the pump and that freed it up. However, I did buy a replacement and Bosch, who...
I did an event with FE a few years back at Almeria. Two Spanish riders turned up on the day and were kicked out after a few hours for riding...
I have seen some made using plastic spoons! sounds odd I know, but I did try one to see if it had a decent curvature and it did. I guess glue in...
I had the pleasure of meeting him on a track day, a very humble and quiet person who let his racing do the talking for him. He has certainly had...
