Separate names with a comma.
Appreciated Gaz. Mighty useful. I'll be rebuilding the motor over the next couple of weeks, and a bit more. I've decided not to rush things in a...
Gear shaft End Float Question .................................................. Ready to split cases and when measuring end float I found no...
Sorry its gone now.
thanks for that. Then, knowing what the sticky stuff in there is like, I'm a little concerned that such lubricating holes may well be blocked,...
I drifted the pushrod out OK, with some amount of firm taps from copper mallet. Its condition is OK. The galling is in fact not chafing, but the...
A handsome looking machine, for sure.
Sure thing Red, thanks. Actually I'll be splitting the cases, because I have a gallery plug backing out, so I can make a very thorough inspection...
Ah, great information, thanks. I do suspect galling on the shaft. I'll proceed to drift it out gently now. John
Please advise: When attempting ot remove the clutch push rod from the clutch side, I can pull it so far and then it appears to stick. I then...
I was sent, by mistake, the wrong part and am to keep it; a decent clutch holding tool for FCC clutch. It's lazer cut, 8mm thick, 600mm long....
It does help, Andrew. I had that cooler noted as a possibility, but what with your photo and all, it makes a decision easier. Especially as I...
Useful to know that in advance. Ta. Some Thoughts based upon present observations:...
Appreciate the warning.
OK just a teenager :D, but definitely headed somewhere. Possibly due to 'Signore' John Wright's fatherly supervision!
Right on, the darker race ball holder is what I had at first mistakenly observed as the inner bearing. You've definitely earned the badge of...
Update: I'm not the best engine builder when it comes to keeping my eye glasses smudge free! I took another look, as per Bumpstart's suggestion,...
Thanks for disagreeing, because it makes me think I should nail down the info concerning fitment type. I aim to. The fact that both mains inners...
you're a gem too you are Bumpstart, Dissassembly ........................ I understood from preliminary reading of Haynes, that the cases were...
Thanks. As I suspected. Must check crank closely on disassembly. :( Can these cranks be built up or not? And has this happened to others , under...
Closer Observation, gallery plug: Although the slot on the plug is clearly visible, indicating only little degree of wear, the plug is at one...
