Separate names with a comma.
For correct "preload" you need to set the "static sag" first. That is more accurate than a measurement on the actual shock absorber itself....
20's or 22's gauge stainless steel locking wire is more than up to the job for bikes. In aviation there is a recommended "twists-per-inch", but I...
I've been round to a mate's today who is using these OZ gass wheels, forged aluminium, in anodised titanium on a special he is building & I can...
The lower fork leg in the above picture looks exactly the same as my '94 750SS legs. The 900SS from the same era was the same, but with the...
My '94 750SS Showa's looks to be about 75cm ish from the bottom of the leg to the top of the tube itself, (not including the top nut). Although I...
Is the piston/bore the original or over-size/aftermarket. You really need to measure the bore, accurately, first to be sure you get the correct...
Where are we taking the measurement from, top to bottom of the leg, top of the leg to the centre of the wheel spindle or some other points ? ;)
And on the wheel with the caliper fitted ........ [ATTACH]
Progress is very slow at the moment, but I have ordered my frame, which should be ready in August & today I collected the rear caliper mounting...
Good to hear you've hopefully sorted your issue & more importantly for other that may follow, what cured the issue. Well done for perseverance...
Correct :upyeah:
Your link to the video doesn't seem to work. However, a correct "rod" for a hydraulic ram should be hardened & surface ground to produce a hard...
Well, I finally got round to fitting this kit to my bike. Slaved the new solenoid to starter-motor cable in to check routing & angle the crimp...
After carefully planning to position your cuts so that they show the internal workings you are trying to display without the moving parts falling...
You are right here. The thing with adding/modifying parts on any bike you have is it never really "adds value" in the eyes of the next purchaser....
I noticed in my 750SS forks that I've just had SD25 cartridges installed by Maxton that they use a different oil in each fork leg, (not weight...
Hopefully it'll be worth the effort, not tried the bike on the road yet since re-fitting the forks because I'm still waiting for a rear sprocket...
Looking at the rust on that clutch it would definitely benefit from stripping, a dam good clean & new plates ;)
Spotted a nice looking 900/750/600 just going round the roundabout, near the hospital/railway station in Buxton today. Looked to be around '94...
Got fed up waiting, so cancelled my order with Sportsbikeshop & bought one off Ebay. Hopefully I won't live to regret this move. I think I was...
