Separate names with a comma.
I've used a Barnett basket for my slipper clutch and also for the standard clutch. It works just fine. I think they are a good option being light...
I'm always mucking about with my slipper. I've never worried at all about plate orientation or order. What is important is the stack height. If it...
Probably the cheapest option is a rubber/foam merchant and get something you can cut to size and glue on
If the nike runs cleanly through the whole rev range on open throttle and the inside of the cans is black then it is most likely the fuel map has...
If you have a few minutes, pull the headlight fairing off. Then you will need to remove the headlights which is just one screw at the fron and...
My bike in different guises. [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
I would use the hammer and chisel method on those screws rather than a drill, which will quite likely damage the threads in the case. I have never...
My opinion only but have a look at the attached. It's American so .004" = 0.1mm and .006" = 0.15mm Vertical Cylinder: Left Intake Opener: .13mm...
Great bike and welcome. Those Ohlins won't need re-springing for you, just have sag/preload and then damping set up for you and you will be...
When you say "prime" what do you mean? All DQ engines are fuel injected so have no accelrator pumps or choke.
Torque the 2 bolts that attach the bracket to the engine case this doesn't affect the stand but needs to be tight to avoid damage. Blue locktite...
I've ridden over honky nuts, in corners before. I agree it's scary but no way will cause a crash unless you are at 10/10 into a corner with no...
My 2cents worth: There are many compromises in the cooling system. I think most people are overly anxious about engine running temps. Ideally the...
I can't see much of a difference between the two. I think that carbon muffler is a little smaller in diameter. Also, it might be the difference in...
So your new 748R heads don't have covers? I guess you've measured new compression ratio with the 'smaller' heads
Buy or borrow a breaker bar. A good sharp pull should get it. You can also use the bar on the 2 rear wheel nuts.
No problems at all. My bike also runs the 5 spoke Marchesini
[ATTACH] [ATTACH] [ATTACH] [ATTACH]
Did you pull the bezel/glass off this instrument? If so I would like to know how and if it came off without damage.
"Ducati Corse" appeared on tachometeres after a certain year. I don't know which year but a guess would be 1998 (TPG). I also guess old stock was...
