Separate names with a comma.
As Paul has said, if you have the crankcase off checking the flywheel nut is always worth it and replace if possible. Locktite is a great...
Gonna post a photo of my old girl (bike not wife) purely because I regret selling her. Bins included [ATTACH]
Nice to see you rebuilding this beastie, how it can be abused like that is beyond me anyhow.. The emulsion is definitely water in the oil, most...
Yeah but if you rev the bike too quickly the Tachos ignite.... Also sorry.
[ATTACH] Update. New clutch plates and steels in. Clutch bled, Chain adjusted, tyres kicked, 22 mile gentle test run... she is oil tight strong...
From what I can tell, the oil tracks may have been blown up into the rear cylinder but i'm speculating. I really cant be sure, suffice to say the...
I'm back with an update... Ordered, received and installed a set of JE pistons, and following installation, swilled out the exhaust pipes with...
Essentially, yes. The bike ran fine until the oil apparently worked its way up past the piston into the combustion chamber. New pistons ordered...
Initially getting the bike running was down to carb set up which has all been sorted now. The bike is running roughly again due to the oil leak...
Right folks, bearing in mind im looking at a new set of pistons, what and where from?
Hi Paul, to be fair, im contemplating getting another set of pistons and thinking of sending the cylinders off to Langcourts for rework, at least...
Hi Chris, this is whats causing my consternation, There is zero evidence of a leak at the o ring seals. If there was I would assume the oil leak...
barrel off and piston out. Its an Arias HH8935. No apparent damage to the rings all of which are free moving. there is a tiny amount of wear on...
Right folks, back again with this damn oil leak...... An hour this morning separated the frame from the engine. I popped the vertical head off to...
Thats exactly where i have run this bike, between the two cast marks. I "reset" the level in order to eliminate any possible excess pressure...
Here is my level marker..... the level is showing a little high as the bike is sat on a paddock stand tilted slightly over to the right. [IMG]...
Pete, I know this may sound a little agricultural but have you tried lubricating the edge of the pulley with a little vegetable oil or similar and...
I stumbled across that issue while researching my "issue". must admit its something I hadn't seen before as ive always run my 900 a little over...
one thing I am going to try before I go down this line is to change the oil and filter and double triple check the oil level. I usually run my...
just had a good firkle around the exhaust port of the vertical cylinder and i'm convinced that is the source of the oil leak as there are what...
