Separate names with a comma.
Really hoping it's not ecu related!
Took it off this morning to make sure I got the correct replacement. Don't know if they all look like this, the rubber cover doesn't seem to come...
That does look very tidy, as we say in Wales! Good find, and welcome to the forum Kenneth.
Hi Comfy, many thanks for the offer - does it look the same, with the actuator lead and plug (although not shown in the parts list)? If so, I'd...
This looks very similar, but I can't wait for it to be delivered from Hong Kong! Think I'll give Snells a call on Monday if Chris's fettling tip...
Thanks Chris, I'll try your fettling instructions first before replacing. I notice they don't show the actuating lead and plug in the parts...
So I guess the part no 39740021A described as "remote switch" is what I want. Although I can't see the other leads that switch the solenoid in...
Is there a non-genuine replacement for the solenoid? I mean not at Ducati parts prices, like my Vauxhall Agila oil pressure switch!
OK, so did the continuity test, first time I tested it showed 547 ohms, so not open circuit as it should be. But when I went back and did it again...
As I have the battery disconnected, I presume I can check for continuity across the battery to starter terminals on the solenoid? If there is, the...
Thanks for that, most likely I guess, I recently had an Exact Start cable kit fitted, maybe my nechanic overtightened them when he fitted the new...
Sorry, forgot to say, 2004 Monster 1000Sie
Rode 50 miles to Fishguard this morning, when I switched the bike off, the starter motor carried on cranking and wouldn't stop. Kill switch did...
After three months, I found my lost spare key in the grass outside my office where I had obviously dropped it. I was cutting the grass when I...
As it requires least skill and tools!
This would be perfect if I had the skill....
Probably best idea so far, should be able to cut the bolt down so it doesn't show too much. Have to have a rummage for something suitable tomorrow.
Of course... but ideally would be QD to re-install dB killers for MOT ....
Don't laugh. .. but after removing the dB killers from my BOS cans, I'm left with an annoying little hole in the end pipe, and, being a bit anal,...
Don't know about using anything like that, I just take the cover off occasionally and clean out any surplus friction plate dust. Others here might...
