Separate names with a comma.
Mount the valve stem in a drill, spin it up and take sand paper then wire wool to the face as it's spinning, making sure not to contact the valve...
If you're that worried, disconnect the oil feed hose to the oil cooler, rig up a funnel inserted into the hose held and lashed vertically and pour...
Use JPDiag every time on my 2007 1098S to reset the service light when performing self servicing. Also use it to balance the Throttle Position...
Following on from my suggestions at post 24, you should be able to check that the starter is or is not receiving 12v at its positive post by...
Like Sam1199, I reckon it's something simple like the side stand switch or kill switch. You mentioned playing around with the stand, and I see...
Blimey. That is a bit nice. Fab bike. Well done pal.
That's proper tasty. Welcome pal. R.
Think outcome was that as long as original beam pattern is maintained with proper cut offs then fitting HID or LED is now NOT an automatic MoT...
I've always reverse bled the clutch and had fab results. It pushes the air upwards to the master cyl and lever mounted bleed screw. Just need some...
4mm internal diameter should do it. Fish tank tubing works well. Or auto washer/wiper tubing. All available at B&Q. However, I use a reverse...
Glad to see my write up still of use rdryder ! My dash still looks like new after I did the screen repair. Yours still ok ?
Ah well. Thx for replying. R.
For the front dip and main headlamp bulbs that is. Thx.
Hi there. Good luck with the sales. You wouldn't by any chance have a pair of rear bulb covers would you please ? Thx. Rich.
Hi there. Do you still have the ground anchor for sale ? PMd you on 1st Jan but not heard anything back. Ta. Richard.
PM'd. Thx. Richard.
Hi mate. Would you take £50 for the ground anchor if still available? Thx. Richard.
Hi there Stevie. Like you, I stuck with Nightbreakers for a while on my 1098 but gave in and fitted 35W HIDs which are a revelation. As a...
Worth checking the Cush Drive rubbers. I had an issue where everything was tight (inc hub nuts both sides) but the rear sprocket was moving...
Yep, mine too, even with new battery, mosfet reg rec and volts steady as a rock at 14.3v when running at any speed and load. Dash still flickering...
