749 749/999 Black Swing Arm Chain Adjusters

we have a few machines. xyz prototracks and fanuc controls. we program most stuff in cam software so we can do the fancy cutter paths

 

the XYZ's are quite good for the small stuff, I used to be able to write custom Macro's in Fanuc, but that was before CAM creally took over.

They look good

 

1no set in black please

 

1 set silver

 

Basically about 400 sets it would seem. Nice to see the spirit of enterprise is unbowed by this buttfuck of a situation.
Someone will be along soon to say this is non-essential work. We all know it is essential, as those chains just won’t adjust themselves!

 

ah while this is all doing on I have also been making PPE for the NHS etc.
if anyone would like to make a donation to keep the flow of stuff gong you can read what's been going on in this Facebook fundraiser. https://www.facebook.com/donate/238181937371422/

 

In that second pic it has taken years off you!

 

Nice one

 

Is it possible to get a (one) set of these in either silver or black, not fussed which colour

 

how many are we up to now?

 

Ill ship world wide guys, obviously that cost will vary.

 

If they’re Yellow then yes. HTH

 

2 sets in black

 

I mean we have to realistic. A batch this size isn’t going to be cheaper than the Gilles ones that were made in the 1000s so the will be around 150-180 a set

 

That's fine with me

 

almost there.

 

Shut it

 

Ok gaffer haha

 

They’re so lush bud nice work