My 1199 attracts a lot of attention thru town too.....mainly because I'm surging and kangaroo-ing on a constant throttle like a learner
Fitted the Bruudt tail tidy this morning. I agree with other posts . It is a bit fiddly, but not having seen R&G or Evotech fitting, can't say if it's any more of a fiddle. There are a few small screws, nuts and washers that could be dropped in the bike. So take care and time. I used the OEM number plate light and indicators. The plate light does not fit properly as the gap is too small and the Allen M4 screws don't line up. However the light stays put at an angle and the cable keeps it in place. The instructions are ok but to get to the front screws for removing the original tail and to fit the tail tidy, it's much easier if you remove the front seat and the plastic trim adjacent to the back end of the front seat. All in all the whole process to about 90 mins including fitting a 7x5 plate and reflector(supplied with the tail tidy). Despite all this, the quality is excellent and fit is snug. Looks really good now. Bruudt is recommended.
