Went To Racebolt Yesterday.....

Discussion in 'Lounge' started by comfysofa, Oct 18, 2014.

Page 2 of 2
  1. #21 Exige, Oct 20, 2014
  2. Standard (Coarse) pitch on an M12 is 1.75mm - Fine could be 1.25 or 1.50
     
    #22 Tobytyke, Oct 20, 2014
  3. Already covered on page 1 in a little more detail ;)
     
    #23 Exige, Oct 20, 2014
  4. ok- that's what I need to know....cheers
     
    #24 comfysofa, Oct 20, 2014
  5. #25 comfysofa, Oct 20, 2014
  6. Just putting a steel rule across it, from the edge of thread to thread it looks almost 2mm so id say yeah, 1.75mm
     
    #26 comfysofa, Oct 20, 2014
  7. think the £180 was to get rid of you!

    metric course thread.
     
    #27 micky1, Oct 20, 2014
  8. 4 threads should be 7mm? Better to check across a few threads.
     
    #28 Exige, Oct 20, 2014
    Last edited by a moderator: Oct 20, 2014
  9. Good point - looks to be 1.5mm although the bolt is quite worn so the threads aren't "sharp" - very blunt....Ill tell him tomorrow although I did tell him to look at this thread so he can see for himself.
     
    #29 comfysofa, Oct 20, 2014
  10. #30 Pete1950, Oct 20, 2014
  11. Nope - I did see your post but I didn't want to have to order something that I would probably use just the once....
     
    #31 comfysofa, Oct 20, 2014
  12. And I answered him! Tetchy today isn't he :confused:
     
    #32 Exige, Oct 20, 2014
  13. Pete - I just ordered one.....tools for the job and all that....I always prefer to have the right tools....so thanks for the link...
     
    #33 comfysofa, Oct 20, 2014
    • Like Like x 1
  14. always asking for the right tool......and Pete cropped up!
     
    #34 andyb, Oct 20, 2014
    • Like Like x 1
  15. #35 finm, Oct 20, 2014
  16. any decent engineering shop would have a guage..i got one...somewhere!
     
    #36 micky1, Oct 20, 2014
  17. Don't know where mine is either!
     
    #37 Exige, Oct 20, 2014
  18. #38 Pete1950, Oct 20, 2014
  19. excellent tool, got me out the you know what a few times.
     
    #39 finm, Oct 20, 2014
(You must log in or sign up to post here.)
Page 2 of 2
Do Not Sell My Personal Information